Technical Training- Servicing Perimeter Systems

Thermal Management Training: Servicing Perimeter Systems

This course prepares the learner to safely and correctly perform critical tasks required to service Vertiv Thermal Management Perimeter Systems with iCOM Controls (DS-VS,
CW, CWA, PDX-S, PCW-S, Challenger, and Smart Row DCR with PDX, MC Condenser, and other Heat Rejection Devices). Student Requirements: A laptop with a USB port is required to attend this training.

Prerequisites: Servicing Vertiv Thermal Management Equipment

Learning Objectives: Upon completion of this course the learner will be able to install, operate, commission, maintain, troubleshoot, and repair Vertiv Thermal Management Perimeter Systems.
In this 4-day, hands on technical training contractors will cover the following:

Safety
Product Introduction
- Unit Identification
- Basic Functionality
Installation
- Start Up/Warranty Inspection
- Pipe Sizing
- Refrigerant Charge

System Hardware
- Component Identification
- Communication
- Setup Procedures

Software Menus and Controls
- Navigation
- Parameters
- Control Logic

Wiring Diagrams
- Troubleshooting
- Signal Flow

Networking
- Unit to Unit Communication
- Teamwork Modes

Maintenance